PANCONTROL PAN 600AD+ Manuel page 34

All manuals and user guides at all-guides.com
- Before using the device, make sure that test leads and the device are in
good condition and the device is working properly (e.g. by connecting
to known voltage sources).
- The device may not be used if the housing or the test leads are
damaged, if one or more functions are not working, if functions are not
displayed, or if you suspect that something is wrong.
- If the safety of the user cannot be guaranteed, the device may not be
operated and secured against use.
- While using this device, hold the test leads only behind the finger
guards - do not touch the probes.
- Never ground yourself while making electrical measurements. Do not
touch any exposed metal pipes, fittings etc., which could have a ground
potential. Ensure that your body is isolated by using dry clothes, rubber
shoes, rubber mats or other approved insulation materials.
- Operate the device in a way that it is not difficult to operate the
network separators.
- Never connect the device to voltage or current sources that exceed the
specified maximum values.
- Disconnect the power supply and discharge the filter capacitors in the
power supply before measuring resistance or testing diodes.
- If the battery symbol appears in the display, replace the battery
immediately.
- Always switch off the appliance and remove the test leads from all
voltage sources before opening the device to exchange the battery or
the fuse.
- Never use the device with the rear cover removed or with the battery
and fuse compartment open!
- Do not use the device near strong magnetic fields (for e.g. welding
transformer), as this can distort the display.
- Do not use the device outdoors, in humid surroundings or in
environments that are subjected to extreme temperature fluctuations.
EN 4