Publicité
Les langues disponibles
Les langues disponibles
Receiving a station through a list
— list-up
You can list up the frequency or the name. For
details on labeling a station, see page 10.
1
Select the band, then press (LIST).
The frequency or station name appears.
2
Press (LIST) repeatedly until the
desired station appears.
After 5 seconds, the unit returns to normal
reception mode.
3
Press (SEEK) +/– to receive the
station.
With the card remote commander
In step 2, to select the station, press M or m .
Downloaded from:
https://www.usersmanualguide.com/
Other functions
Changing the sound settings
Adjusting the sound
characteristics — BAL/FAD/SUB
You can adjust the balance, fader, and subwoofer
volume.
1
Press (SEL) repeatedly until "BAL,"
"FAD" or "SUB" appears.
The item changes as follows:
t MID*
t HI*
LOW*
1
1
BAL (left-right) t FAD (front-rear) t
SUB (subwoofer volume)*
*1 When EQ3 is activated (page 9).
*2 When the audio output is set to "SUB"
(page 10).
"ATT" is displayed at the lowest setting, and can
be adjusted up to 20 steps.
2
Press the volume +/– button
repeatedly to adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Note
Adjust within 3 seconds of selecting the item.
With the card remote commander
In step 2, to adjust the selected item, press < , M , ,
or m .
Adjusting the equalizer curve
— EQ3
You can adjust and store the equalizer settings
for different tone ranges.
1
Select a source, then press (EQ3)
repeatedly to select the EQ3 type.
2
Press (SEL) repeatedly until "LOW,"
"MID" or "HI" appears.
3
Press the volume +/– button
repeatedly to adjust the selected item.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
Repeat steps 2 and 3 to adjust the equalizer
curve.
To restore the factory-set equalizer curve,
press and hold (SEL) before the setting is
complete.
continue to next page t
t
1
2
9
Publicité
