Skil RH170201 Guide D'utilisation page 18

DRIVING NUTS AND BOLTS
WARNING
dusty, also wear a dust mask.
NOTICE: When using hex bits, use the supplied magnetic insert bit holder and use bits with
hex shanks that are at least 40mm long.
Variable-speed control must be used with caution for driving nuts and bolts with socket-set
attachments. The technique is to start slowly, increasing speed as the nut or bolt runs down.
Set the nut or bolt snugly by slowing the tool to a stop. If this procedure is not followed, the
tool will have a tendency to torque or twist in your hands when the nut or bolt seats.
18
Always wear safety goggles or safety glasses with side shields
during power tool operation or when blowing dust. If operation is