Skil RH170201 Guide D'utilisation page 13

Mode Selector (Fig. 5)
Your tool is equipped with a mode selector to quickly switch from normal drilling/screw-driving
mode to rotary hammer mode.
For normal drilling/screw-driving, place the selector in the position.
For rotary hammering, place the selector in the position.
NOTICE:
The hammer mechanism is activated by applying a slight pressure on the tool when the drill
bit is in contact with the workpiece. Performance will not improve by applying more pressure
on the tool.
NOTICE: Do not switch the operating mode when the tool is running.
Fig. 5
Rotary Hammer
Normal Drilling/Screw-driving
LED Light (Fig. 6)
Fig. 6
Your tool is equipped with an LED light, located
on the base of the tool, which illuminates when
the variable-speed trigger switch is squeezed.
This provides additional light on the surface
of the workpiece for operation in lower-light
areas.
The LED light will automatically turn on with
a slight squeeze on the trigger switch before
the tool starts running, and will turn off 8 to 12
seconds after the trigger is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED light will rapidly flash.
Rest the tool for a while or place the tool and
battery pack separately under air flow to cool.
The LED light will flash more slowly to indicate that the battery pack is at low-battery capacity.
Recharge the battery pack.
13