Variable-Speed Trigger Switch - Skil RH170201 Guide D'utilisation

Direction-of-Rotation (Forward/Center-Lock/Reverse) Selector
WARNING
injury.
Your tool is equipped with a direction-of-rotation selector, located above the trigger switch.
This selector is designed for changing the direction of rotation of the bit and for locking the
trigger in the "OFF" (center-lock) position (Fig. 3).
a. Position the direction-of-rotation selector to the far left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the far right of the tool for reverse rotation.
c. Position the switch in the "OFF" (center-lock) position to help to reduce the possibility of
accidental starting when not in use.
NOTICE: To prevent gear damage, always allow the rotary hammer to come to a complete
stop before changing the direction of rotation.
NOTICE: The rotary hammer will not operate unless the direction-of-rotation selector is
engaged fully to the left or right.
Fig. 3

Variable-Speed Trigger Switch

(Fig. 4)
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON"
by depressing the trigger switch or "OFF" by
releasing the trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
12
After tool use, lock the direction-of-rotation selector in the "OFF"
position (center-lock) to help prevent accidental starts and possible
Forward Center-Lock
Fig. 4
Reverse