Operating Instructions - Skil RH170201 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-contain ng products, etc, can cause a short
circuit.
WARNING
could result in serious personal injury.
WARNING
misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
bling parts.
This cordless rotary hammer must be used only with the battery packs and charger
listed below:
2Ah
SKIL BY519701
NOTICE: Please refer to the battery and charger manuals for detailed operating information.
To Attach/Detach Battery Pack
(Fig. 2)
Lock the trigger switch "OFF" on the tool by
placing the direction-of-rotation (forward/
center-lock/reverse) selector in the center
position before attaching or detaching the
battery pack.
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves in the tool, and then slide the battery
pack onto the tool.
To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool.
NOTICE: When placing the battery pack in the tool, be sure that the raised rib on the battery
pack aligns with the groove inside the tool and that the latches snap into place properly.
Improper attachment of the battery pack can cause damage to internal components.
WARNING
always be locked in the center position when the tool is not in use or when carrying it
at your side.
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack, or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced. Use of this product with damaged or missing parts
Do not attempt to modify this tool or create accessories not recom-
mended for use with this tool. Any such alteration or modification is
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assem-
Battery Pack
4Ah
SKIL BY519601
Battery tools are always in operating condition. Therefore, the
direction-of-rotation (forward/center-lock/reverse) selector should
5Ah
SKIL BY519603
Fig. 2
Attach
Battery- Release Button
Charger
SKIL SC535801
Detach
11