Skil RH170201 Guide D'utilisation page 14

Install and Remove Accessories (Fig. 7)
WARNING
Your tool is equipped with an SDS Plus chuck with a built-in Hex collet for 1/4 inch bits.
Lock the trigger switch "OFF" on the tool by placing the direction-of-rotation selector in the
center position.
To install the accessory:
a. For SDS+ accessories:
Clean the accessory and lightly lubricate it before inserting it into the chuck.
–
Pull back the locking sleeve and insert the accessory in the SDS+ chuck while turning and
–
pushing it until it engages; the accessory locks in position automatically.
b. For hex bits:
When using hex bits, a magnetic insert bit holder with a length of the hexagon shank of at
–
least 40mm is required (included).
Pull back the locking sleeve and insert the bit into the chuck as far as it will go.
–
Pull the accessory to check that it is firmly locked in place.
–
To remove the accessory:
Pull back the locking sleeve and remove the accessory from the chuck.
–
NOTICE: The SDS+ accessory requires freedom of movement, which causes eccentricity
in the revolutions when tool is off-load; however, the accessory automatically centers itself
during operation without affecting drilling precision.
Fig. 7
40mm (hex shank)
WARNING
14
Do not use bits with a damaged shank.
Use protective gloves when removing the bit from the tool, or first
allow the bit to cool down. The bit may be hot after prolonged use.
Locking Sleeve