Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
CAUTION: Before installing mounting bracket to surface pre-adjust the four mounting
screws "A" on the base of the dome camera to best match the mounting bracket locked
position. Unscrew the locking screw on the side of the dome's base and fit the tab of the
mounting bracket into the locking slot. Screws "A" should not be too tight or too loose
when the dome is in the locked position. After setting the proper positions of screws
"A" remove the mounting bracket and install it to the proper surface. If it is too difficult
to lock the dome in position after the mounting bracket has been installed readjust the
screws "A" by unscrewing them a small amount and try to install dome camera again.
Basic Configuration of Dome Camera System
No.
Connector
1
3-pin terminal block
2
2-pin terminal block
3
5-pin terminal block
4
4-pin terminal block
5
BNC black
6
BNC yellow
The dome camera must be installed by qualified service personnel in accordance with all
local and federal electrical and building codes.
8
Description
CAMERA POWER
TX+: RS485+ (A)
TX-: RS485- (B)
A1: ALARM INPUT 1
A2: ALARM INPUT 2
A3: ALARM INPUT 3
A4: ALARM INPUT 4
GND
AO1: ALARM OUTPUT 1
GND
AO2: ALARM OUTPUT 2
GND
HD OUTPUT
CVBS OUTPUT
Publicité
