Kenmore ELITE C970 Guide D'utilisation Et D'entretien page 5

Installation Instructions
Clearances and Dimensions
A. Provide adequate clearances between the range and adjacent combustible surface (1.3cm (1/2") to the cabinet side walls
and the rear wall).
B. Location—Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
C. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid
and level.
FRONT
VIEW
76.2 cm (30")
Minimum *
Minimum to 1.3 cm
wall on either (1/2")
side of range.
91.4 cm
(36")
* 76.2 cm (30") minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or
metal cabinet; or 61 cm (24") minimum when bottom of wood or metal cabinet is protected by not less than 0.64 cm (¼")
flame retardant millboard covered with not less than 0.038 cm (0.015") stainless steel, 0.061 cm (0.024") aluminum or
0.051 cm (0.020") copper. 1.3 cm (½") clearance is minimum for the rear and sides of the range. Follow all dimensions re-
quirements provided above to prevent property damage, potential fire hazard, and incorrect countertop and cabinet cuts.
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage spacelocated above
the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a
range hood that projects horizontally a minimum of 12.7 cm ( 5") beyond the bottom of the cabinets.
Electrical Hook-Up
This appliance must be connected to a grounded 120/240 volt or 120/208 volt,
45 AMP. Range outlet. If no outlet is available, have one installed by a qualified
electrician.
Location
Set your new range 1.3 cm (1/2") away from the rear wall and line it up with
the kitchen counters. Make sure there is at least 1.3 cm (1/2") of clearance be-
tween each side of the range and the kitchen counters. Allow 7.6 cm (3") min.
clearance between your range and the refrigerator, if they are side by side.
All manuals and user guides at all-guides.com
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED TECHNICIAN.
IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE
THESE INSTRUCTIONS FOR FUTURE REFERENCE.
C
Minimum to
45.7 cm
cabinets on ei-
(18")
ther side of
range.
B
RANGE
SIDE
VIEW
30"
33 cm
(13")
Maximum depth for
cabinets above
range top.
114.3 cm (45")
5
DIMENSIONS
A B
76.2 cm (30") 78.7 cm (31") 76.2 cm (30")
66 cm (26")
A
122 cm (48")
Maximum
Door Open
C
91.4 ± 0.3 cm
(36 ± 1/8")