Cassese CS1 CART Manuel D'utilisation Et De Pièces page 7

Put the first moulding in front of the back fence 1 and slide the moulding in
contact with the 2nd back fence 2.
1
E
6
10
1
5
1 position
st
Non contractual document - Cassese France
All manuals and user guides at all-guides.com
WEDGE
2
EXIT
2
10
Setting up the stapling position
close to the outside of the frame :
Move forward the sliding table E until the
place where you want to insert the wedge(s)
has been reached by the WEDGE EXIT (see
picture). Then bring the wedge position
stop handle 6 against the stapling stop 10
and tighten it.
Setting up the stapling position
close to the inside of the frame :
Move backwards the sliding table E until
you have reached the furthest position to
the inside of the frame where you want to
insert wedge(s).
Then bring the wedge position stop handle
5 against the stapling stop 10 and tighten it.
Now the two positions of joining are
set and the sliding table can move only
within the limits of these two positions.
4
- Document non contractuel
®
Last
position
Wedges between
the first and the
last position