Cassese CS1 CART Manuel D'utilisation Et De Pièces page 10

After selecting and setting the wedge positions (page 4 & 5), check the distance
between the clamp and the moulding (page 6). Load the required type (softwood,
hardwood or MDF) and size of wedges (page 4).
1 step : Put the first moulding in front of the back fence 1 and push it so that its
st
mitre end reaches the other back fence 2.
2 step : Holding it so, put the second moulding against back fence 2 and slide it
nd
until it reaches the first moulding.
3 step : Holding the mouldings in place against each other, hold the back fences 1
rd
& 2 with your thumbs. Move the sliding table E backwards until the wedge position
stop handle 5 reaches the stapling stop 10.
4 step : Keeping the mouldings secure, slowly push down the pedal 7.
th
When the the magnetic adjustable rod clamp assembly 8 will press down on the
mouldings, speed up the movement so that the wedge is inserted more easily.
5 step : If there is a second wedge position (with wedge position stop handle 6),
th
just repeat the same operation by moving forward the mouldings and the sliding
table E until wedge position stop handle 6 reaches the stapling stop 10 and repeat
step 4.
NOTE* : If stapling more than one wedge in any position is desired then repeat 4
step.
9
6
5
10
Non contractual document - Cassese France
All manuals and user guides at all-guides.com
JOINING THE FRAME
3
2
4
11
7
7
8
1
- Document non contractuel
®
th