Cassese CS1 CART Manuel D'utilisation Et De Pièces page 14

Take pliars to remove the wedge driver blade and twist it to unlock it.
D) INSTALLATION OF A NEW WEDGE DRIVER BLADE
1.
Apply some grease at the bottom
of the wedge distributor block and
insert a new wedge driver blade into
the block with its hole (in the circle)
downwards.
3.
Tighten the screw of the wedge
distributor block paying attention to
level it with the working table.
Push the wedge driver blade fully in with a piece of wood or moulding
; press the pedal to engage the wedge driver blade entirely.
Check the wedge driver blade installation, it should slide smooth with
no resistance.
Non contractual document - Cassese France
All manuals and user guides at all-guides.com
3
rd
DO NOT PULL IT STRAIGHT UP !
5.
11
step
2.
Replace the wedge distributor block in
its housing with the window towards the
cartridge channel and install the wedge
distributor block. Then, lock it using the
2,5mm Allen key.
4.
The upper end of the wedge driver blade
stays out of the block. Reinstall the magnetic
adjustable rod clamp assembly in order to
proceed with the following step.
- Document non contractuel
®