Cassese CS1 CART Manuel D'utilisation Et De Pièces page 6

The CS1 CART is designed to join mouldings in one, two or more positions without
limitation of the number of wedges in any of those places. The selection depends
on the width and height of the moulding to join.
2mm MINIMUM
As a general rule, a MINIMUM 2 mm clearance (less than 1/8") above the wedges
shall be respected.
Same size wedges can be stacked in order to avoid changing the size of wedge
when joining tall mouldings.
AS A GENERAL RULE, THE WEDGE POSITIONS MUST BE SELECTED
VERTICALLY TO THE HIGHEST POINTS OF THE MOULDINGS.
SETTING AND STORING THE WEDGE POSITIONS
Unlock the wedge position stop handles 5 and 6.
6
All manuals and user guides at all-guides.com
ADJUSTMENTS
SELECTION OF WEDGE POSITIONS
2mm MINIMUM
Non contractual document - Cassese France
3
- Document non contractuel
®
140mm
stroke
5