Andis DBLC-2 Instructions D'utilisation Et D'entretien page 4

17. Keep the appliance dry.
18. WARNING: During use, do not place or leave appliance
where it may be 1) damaged by an animal or 2) exposed to
the weather.
19. WARNING: For the purposes of recharging the battery, only
use the detachable supply unit provided with this appliance.
20. WARNING: Cutting blades may become hot after
prolonged use.
21. This appliance is intended for trimming purposes only.
SAVE THESE INSTRUCTIONS
This appliance is designed to be used in commercial areas
OPERATING INSTRUCTIONS
• The battery must be removed from the appliance before it is recycled.
• The battery is to be recycled as a lithium-ion battery.
UNIVERSAL AC/DC POWER ADAPTER
1. Remove the wall adapter and charger from the carton.
2. Note the charger comes standard with a universal AC voltage wall adapter and interchangeable
plugs for use in most countries around the world (Figures A-E).
3. To attach the desired plug to the wall adapter, align the slots on the plug to the ribs on the wall
adapter and slide into place. The plug will "click" into place when properly attached. To remove,
locate the button marked "push" on the wall adapter. Press the button and slide the plug from the
wall adapter. The plugs for the various countries all attach and remove using the same method
(Figure F).
4. Connect the power cord to the back of the charger and then insert the transformer into an AC outlet.
CHARGING UNIT
To charge, plug wall adapter into 100-240V, 50/60 cycle AC electrical outlet or as noted on the unit.
Make sure the proper input plug is attached to the wall adapter. Plug power cord directly into back
of charging stand. The battery pack may be charged while on the clipper or separately. To charge
the battery pack while in the unit, place clipper into the pocket on the charging stand. NOTE: the
clipper should be charged with the switch in the OFF position. To charge the battery pack separately,
remove the battery pack by pressing the tab on the back of the battery (Figure G), sliding the
battery out and placing in the pocket on the charger (Figure I).
Before using your clipper for the first time, make sure the battery has been fully charged. Note
that it is normal for the clipper and wall adapter to feel warm to the touch when charging. This is
especially true if the battery has been deeply discharged as indicated by the clipper indicator light
turning red (Figure H) while the clipper is running. The clipper should be charged with the switch in
the OFF position.
To start clipper, move power switch to ON position. To stop clipper, move power switch back to
original position (Figure H).
CHARGING STAND INDICATOR LIGHTS
When the battery is charging, the charging stand indicator light will turn red. The charging stand
indicator light will turn green when the clipper is fully charged (Figure I). Under normal operation
the indicator lights on the clipper will always be dark when the unit is in the charger stand.
Note that the clipper or battery can be removed at any time during the charging cycle without
harming the clipper or battery.
4