Hudora THE SKATE FACTORY Stuntboy Mode D'emploi page 4

Fig. 1
Fig. 2
Fig. 3
Care instructions:
Please only use original spare parts for your own safety. You can purchase these from HUDORA
(address below). Clean the scooter only with a dry cloth or moist cloth and not with special cleaners!
HUDORA GmbH · Jägerwald 13 · D-42897 Remscheid · Germany · www.hudora.de · service@hudora.de
All manuals and user guides at all-guides.com
Fasten the wheels with the fastening washers and
tighten axle nuts tightly.
Assembling the handlebar/brakes:
1. Take the pre-assembled handlebar. Loosen the clamp
wedges at the lower section of the handlebar so far
that they fit into the frame opening. Before tightening,
pay attention that the handlebar has the correct
position to the wheel.
2. Loosen all screws and washer of the pre-assembled
handlebar, place the handlebar between the metal
holders and screw this tight again. Pay attention to
the correct position of the handlebar. (Fig. 1)
3. Attach the foam padding on the handlebar as well as
the Stuntboy Velcro cover on the cross-bar of the
handlebar. (Fig. 2)
4. The brake pads on the front wheel are already pre-
assembled but must be checked for correct position
and braking capacity before every run. (Fig. 3)
5. Fasten the handbrake on the right side of the
handlebar.
6. Press the rear wheel brake pad into the provided
space behind the footboard.
If required, you can screw the two BMX-Pads to the rear
axletrees!