IKEA ENASTAENDE Serie Mode D'emploi page 10

ENGLISH
German
degrees
(°dH)
< 4
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener
manually and electronically.
Manual adjustment
1
Electronic adjustment
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'SET-
TING AND STARTING A PROGRAMME'.
2. Press and hold buttons (4) and (5) at the
same time until the indicators of buttons
(3), (4) and (5) flash.
3. Press button (3).
• The indicators of buttons (4) and (5)
go off.
• The indicator of button (3) continues
to flash.
• The acoustic signals operate, e.g. five
intermittent acoustic signals = level 5.
• The display shows the setting of the
water softener, e.g.
4. Press button (3) again and again to
change the setting.
5. Deactivate the appliance to confirm the
setting.
All manuals and user guides at all-guides.com
Water hardness
French mmol/l
degrees
(°fH)
< 7 < 0.7
2
Turn the water
hardness dial to the
position 1 or 2.
= level 5.
Clarke
degrees
< 5
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent this, after the
replenishment, start a programme.
1
3
Put 1 litre of water
in the salt container
(only for the first
time).
5
10
Water softener
adjustment
Manual Elec-
tronic
2) 2)
1 1
2
4
Put 1 kg of salt in
the salt container.
6