Symbol Explanation; Symbols - Husqvarna 91VG Manuel D'utilisation

Symbols

WARNING! Clearing saws, brushcutters
and trimmers can be dangerous!
Careless or incorrect use can result in
serious or fatal injury to the operator or
others.
Read through the Operator's Manual
carefully and understand the content
before using the machine.
Always use
• A protective helmet where there is a
risk of falling objects
• Ear protection
• Approved eye protection
This product is in accordance with
applicable CE directives.
Saw attachment
This machine is not electrically
with shaft insulated. If the machine touches or
comes close to high-voltage power lines
it could lead to death or serious injury.
Electricity can jump from one point to
another by arcing. The higher the
voltage, the greater the distance
electricity can jump. Electricity can also
travel through branches and other
objects, especially if they are wet.
Always keep a safe distance of at least
10 m (30 ft) between the machine and
high-voltage power lines and/or any
objects that are touching them. If you
need to work closer than this always
contact the relevant power company to
make sure the power is switched off
before you start work.
Saw attachment This machine is not electrically
without shaft insulated. If the machine touches or
comes close to high-voltage power lines
it could lead to death or serious injury.
Electricity can jump from one point to
another by arcing. The higher the
voltage, the greater the distance
electricity can jump. Electricity can also
travel through branches and other
objects, especially if they are wet.
Always keep a safe distance of at least
10 m (30 ft) between the machine and
high-voltage power lines and/or any
objects that are touching them. If you
need to work closer than this always
contact the relevant power company to
make sure the power is switched off
before you start work.
2
– English

SYMBOL EXPLANATION

Always wear approved protective gloves.
Use anti-slip and stable boots.
Other symbols/decals on the machine refer to
special certification requirements for certain
markets.
Checks and/or maintenance should be
carried out with the engine switched off,
with the stop switch in the STOP
position.
Always wear approved protective gloves.
Regular cleaning required.
Ocular control.
Approved eye protection must always be
used.
Chain oil and chain oil flow adjustment