Table Des Matières; List Of Contents - Husqvarna 91VG Manuel D'utilisation

Husqvarna AB has a policy of continuous product
development and therefore reserves the right to modify the
design and appearance of products without prior notice.
Read through the Operator's manual
carefully and understand the content before
using the machine.
These instructions supplement the instructions that were
included with the machine. For other procedures, please
refer to the opertaing instructions for hte machine.
!
WARNING!
Under no circumstances may the design
of the machine be modified without the
permission of the manufacturer. Always
use genuine accessories. Non-authorised
modifications and/or accessories can
result in serious personal injury or the
death of the operator or others.
!
WARNING!
This accessory may only be used together
with the intended clearing saw/trimmer,
see under heading "Approved
accessories" in chapter Technical data in
the machine's Operator's Manual.
The machine is only designed for tree pruning.
CONTENTS
SYMBOL EXPLANATION
Symbols ............................................................................... 2
CONTENTS
List of contents .................................................................... 3
SAFETY INSTRUCTIONS
Cutting equipment .............................................................. 4
Specification of blade and chain ........................................... 4
Sharpening your chain and adjusting raker clearance ........... 5
Tensioning the saw chain ..................................................... 7
Lubricating cutting equipment ............................................ 7
Checking wear on cutting equipment .................................. 8
Safety insructions when using the machine .......................... 9
Basic working techniques ................................................... 10
WHAT IS WHAT?
What is what on the machine? ........................................... 12
ASSEMBLY
Fitting the cutting head (Saw attachment with shaft ) ........ 14
Fitting the cutting head (Saw attachment without shaft) .... 14
Mounting guide bar and chain ........................................... 14
Fitting the hanging ring ..................................................... 14
Adjusting the harness ......................................................... 14
Filling with oil ................................................................... 15
Control before starting ....................................................... 15
TECHNICAL DATA
Technical data .................................................................... 16

List of contents

3
English -