Final Assembly - LEMAN RAD260 Manuel D'utilisation

2.0 Final Assembly

2.1 Place legs into motor housing and secure with
hex. Bolt M8x16, spring washerφ8 and hex. nut
M8.
2.2 Push rubber feet onto legs.
2.3 Take off both of the Cover rails and fix the in-feed table.
2.5 Put on the out-feed table and press the Clamp,
then lock the two of Lock levers.
2.4 Attach chip ejection hood to extrusion using the 4
sheet metal screws supplied.
2
EN