To Stop The Product; Maintenance - Husqvarna BV 30i Manuel D'utilisation

c) Put the end of the beam on each of the parallel
strips and operate the product (C). Make sure
that the beam follows the contour of the parallel
strips.
C
To operate the cruise control function
1. Push the power trigger to select the optimal vibration
frequency for your operation.
2. Push the cruise control button to set the selected
vibration frequency. The LED comes on.
3. Release the power trigger to operate the product
with the cruise control function.
4. To increase the vibration frequency, do the
procedure that follows.
a) Push the cruise control button to stop the cruise
control function.
b) Push the power trigger to the correct level. Then
push the cruise control button, to set the new
cruise control speed.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
12

Maintenance

Read and understand the

To stop the product

1. Release the power trigger.
2. Push and hold the ON/OFF button until the display
LED goes off.
3. Push the release buttons on the battery and pull the
battery out.
1493 - 001 - 27.05.2021