Publicité
Les langues disponibles
Les langues disponibles
2 Safety
• SB3.8-1TP-US-40 (Sunny Boy 3.8-US)
• SB5.0-1TP-US-40 (Sunny Boy 5.0-US)
• SB6.0-1TP-US-40 (Sunny Boy 6.0-US)
• SB7.0-1TP-US-40 (Sunny Boy 7.0-US)
• SB7.7-1TP-US-40 (Sunny Boy 7.7-US)
• SB3.0-1SP-US-41 (Sunny Boy 3.0-US)
• SB3.8-1SP-US-41 (Sunny Boy 3.8-US)
• SB5.0-1SP-US-41 (Sunny Boy 5.0-US)
• SB6.0-1SP-US-41 (Sunny Boy 6.0-US)
• SB7.0-1SP-US-41 (Sunny Boy 7.0-US)
• SB7.7-1SP-US-41 (Sunny Boy 7.7-US)
The inverter still complies with the standard after the product has been installed.
The product must only be operated with temperature sensors with a Pt100 measuring shunt or a
Pt1000 measuring shunt.
The product must only be operated with irradiation sensors that can output a current signal in the
range from 0 mA to 20 mA or 4 mA to 20 mA or a voltage signal in the range from 0 V to +10 V.
When using the Sunny Tripower X, the product must only be operated with irradiation sensors with
a current signal. Irradiation sensors with a voltage signal are not compatible with the
Sunny Tripower X.
The product must only be operated with anemometers with impulse output for S0 impulses in
accordance with DIN EN 62053-31 (IEC 62053-31).
The product must only be operated with energy meters with S0 interface in accordance with
DIN EN 62053-31 (IEC 62053-31).
The S0 interface of the product cannot be used for the Sunny Tripower X.
A list with SMA Sensor Module compatible products is available at www.SMA-Solar.com.
All components must remain within their permitted operating ranges and their installation
requirements at all times.
The product is approved for the US and Canadian market.
Use SMA products only in accordance with the information provided in the enclosed
documentation and with the locally applicable laws, regulations, standards and directives. Any
other application may cause personal injury or property damage.
Any use of the product other than that described in the Intended Use section does not qualify as
appropriate.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient, dry place for future reference and observe all instructions contained therein.
This document does not replace any regional, state, provincial, federal or national laws, regulations
or standards that apply to the installation, electrical safety and use of the product. SMA Solar
Technology AG assumes no responsibility for the compliance or non-compliance with such laws or
codes in connection with the installation of the product.
The type label must remain permanently attached to the product.
6
MDSEN-US-40-IS-xx-14
SMA Solar Technology AG
Quick Reference Guide
Publicité
