Publicité
Les langues disponibles
Les langues disponibles
Parts of the hood
The extractor hood consists of the following parts
1. Control
2. Grease filter
3. Exhaust nozzle ø120mm
4. Cooker hood body
5. Lighting (LED)
Dimension Drawings
Assembly
1. examination
Before starting the actual installation, the device should be checked. In addition to the control of
externally recognizable damage, a function check has to be done. Take out the device from the
packing, get rid of all packing materials and put the device with the back on the floor / table. After
connecting to a power supply, the lighting as well as the function of each stage should be checked.
Please take care that exhaust outlet is open through check.
2. Preparation and Installation
Drill 2 holes (A,B) in the wall for the 40 mm deep dowel, insert the dowels and screw in 2 universal
screws 4,5 x 40 (included) so that the distance between the wall and the screw head is 5 mm. Place
the housing on the screw heads and fix it to the wall.
If required, the cooker hood can also be screwed to a wall-mounted cabinet on the upper side of the
hood housing (C, D, E, F).
In a suitable place, it is necessary to cut an exhaust opening with a diameter of 120 mm in the bottom
of the cabinet. It is advisable to make this hole slightly larger to compensate for measurement
inaccuracies.
Publicité
