Publicité
Les langues disponibles
Les langues disponibles
Drainage opération
When the air conditioner is in dehumidifier mode (dry) remove the drain plug on the back of the
unit, install the drain connector (universal 5 / 8˝ female connector) with a 3/4 ˝ pipe (purchased
locally).
NOTE: Make sure the hose is secure so there is no leakage. Point the pipe to the drain, making sure
there are no kinks that can prevent water flow. Place the end of the hose in the discharge hose and
make sure the end of the hose is down to allow the flow of water to flow smoothly. When the
continuous drain hose is not in use, make sure that the drain plug and knob are properly installed to
prevent leakage.Lorsque « P1 » s'affiche sur l'écran cela signifie que le réservoir d'eau inférieur est
plein, le climatiseur s'arrête alors de fonctionner. Cependant, le moteur du ventilateur continuera à
fonctionner (ceci est normal).
When "P1" is displayed, please empty the water tank as soon as possible. Thanks to the wheels,
you can move the air conditioner where the water can be directly and
easily drained (example: toilets, sewers, etc.). If not, place a recovery
tank under the water outlet.
To do this, you must unscrew the nut on the back of the unit and remove
the cap, the water will drain naturally. To facilitate drainage, you can tilt
your air conditioner very slightly to the rear.Une fois le flux d'eau estompé,
vous pouvez à nouveau fixer le bouchon puis l'écrou.
The symbol "P1" must disappear, if the symbol is still present, contact the
help desk.
CAUTION :
When you want to move your air conditioner and the water tank is full, make sure to move it
horizontally and perfectly stable to avoid any risk of water spillage or leakage (inside the unit
but also outside).
53
Publicité
