Climadiff CLIMA10K1 Manuel D'utilisation page 47

Operation Method
Cooling mode
When the A/C enters cooling mode automatically or cooling mode is selected after power

ON, the cooling indicator lamp lights up.
 Press Up/Down key to adjust setting temperature (17℃~30℃).
Press FAN SPEED on the remote controller to choose High/Low speed.

Fan mode
When pressing mode key or choosing Fan mode by pressing the remote controller, the wind

indicator lamp lights up.
Press FAN SPEED to choose High/Low speed.

Temperature can't be set.

Do not put the duct to window

Dehumidifying mode
When pressing mode key or choosing dehumidifying mode by pressing the remote

controller, the indicator lamp lights up.
After choosing this mode, operation state is determined by environmental temperature:

when environmental temperature is higher than 17℃, the operation state is the same as that
of cooling mode; when environmental temperature is lower than 15℃, the operation state is
the same as that of fan mode.
In the dehumidifying mode, the motor will work in low speed, and cannot be adjust.

 In this mode, the temperature cannot be adjust.
Do not put the duct to window

Heating mode
When pressing mode key or choosing heat mode by pressing the remote controller, the

indicator lamp lights up
Press Up/Down key to adjust setting temperature (17℃~30℃).

 Press FAN SPEED to choose High/Low speed.
 Do not put the duct to window
Sleep/Eco operation:
This feature can be activated from the remote control ONLY. To activate SLEEP feature, the set

temperature will increase(cooling) or decrease(heating) by 1°C/2°F
(or 1°F) in 30 minutes. The set temperature will then increase(cooling) or decrease(heating) by

another 1°C/2°F (or 1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it returns to the originally selected

temperature. This ends the Sleep mode and the unit will continue to operate as originally
programmed.
47