Sensopart FT 80 RLA Instructions De Service Et De Montage page 60

B. Adjustment of the analogue output (if required):
No. Action Picture
follows
1. Set 4 mA point:
Q Q
1
I OK
C FA
push
15x
2. Set 20 mA point:
Q Q
1
I OK
C FA
push
16x
C. Examples of use
Differential thickness measurement with wide wooden boards
Two opposite facing sensors enable non-contact measurement and control of the thickness of the wood or wooden
boards. A change in thickness is indicated at the analogue output of the master. 12 mA corresponds with the taught
reference thickness of the object.
INFORMATION
Although a FT 80 RLA sensor only has a measuring range of 500 mm respectively, it is possible to
measure excess width using master-slave mode. The solution is in the alignment of both sensors
(illustr. 20). The necessary measuring range depends on the maximum difference in thickness.
Slave
The analogue output on the master sensor supplies
INFORMATION
To achieve optimum use of the measuring range, the object must be positioned in the centre of
the measuring range.
60
Action
Select function n° 16 (set 4 mA point). Position
2
object at desired 4 mA point. Push
Select function n°17 (set 20 mA point). Position
2
object at desired 20 mA point. Push
Nominal dimension
information on thickness.
Reaction
Once the
.
SET
the current measured value corre-
sponds with the 4 mA point of the
analogue output.
Once the
.
SET
the current measured value corre-
sponds with the 20 mA point of the
analogue output.
Master
Control
FT 80 RLA Disctance sensor - GB - 068-13715 - 01.09.2014-05
Mounting and
operating instructions
SET
key has been activated,
SET
key has been activated,
Illustr. 22
15500150