Sensopart FT 80 RLA Instructions De Service Et De Montage page 50

The LEDs (illustr. 11) indicate the selected menus and configurations.
BA ZA
SET
Illustr. 11
15500144
7.2 Setting functions with the control panel
First, activate set-up mode  push
When green LED flashes, select function (according to table 7.2.2) with
When all functions are set (table 7.2.2), leave set-up mode  push
then stored and the sensor is in Run mode.
7.2.1 Quick user guide (068-14531) see fold-out page
7.2.2 Possible configurations and operating modes
No. Action Picture
follows
1 Q : Set as switching input or output
1
No
Q Q
1
I OK
action
C FA
2 Q : Teach-in of 1
st
1
Q Q
1
OK
I
C FA
push
1x
50
LED Colour In operating mode
BA Green Operating indicator (LED lights up
when sensor is ready for use)
ZA Red
Q Yellow Lights up when Q
1
is active
Q Yellow Lights up when Q
2
I Green Lights up when Q
Q
1
OK Green Good Target (lights up when object
is detected and in measuring
range)
C Green Lights up when sensor is program-
med as master or slave
FA Green Lights up when Q
or Q
active
SET and
Action Reaction / Status indicator „ZA" (red)
Switch with ON, when Q
2
OFF, when Q
SET
switching point
Save mea- ON, if measured value valid
2
sured value OFF, if measured value invalid
SET
with
SET
When the key is released, the current measured value is stored as the 1
point of the Q switching output.
1
input/output
1
output is active
2
trigger input or
1
enable input function is active
autom. centre
1
autom. zero function is
1
simultaneously for 3 s (or longer), until LED BA (green) flashes.
SET
is defined as switching output
1
is defined as input
1
FT 80 RLA Disctance sensor - GB - 068-13715 - 01.09.2014-05
operating instructions
In configuration mode
LED flashes when set-up mode
is active.
Status indicator:
Lights up when function is active.
Off, when function is not active.
During teach-in: confirmation
signal
Table of functions in chapter 7.2.2
onwards explains the significance
of the Q , Q , I, OK, C and FA
1 2
LEDs in set-up mode.
.
and simultaneously. All settings are
Factory setting
Q = switching output
1
(„ZA" = ON)
Switching point at half
measuring range
Mounting and
switching
st