Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Troubleshooting
Track down the cause of trouble using the following chart.
It may save you a trip to your nearest Nikon service center.
Problem
a The battery is installed with wrong
The shutter
cannot be
released.
a The camera is off.
a The green LED blinks.
a No indicator on the LCD panel.
a The camera-to-subject distance is
a The green LED blinks.
The flash
does not
fire.
a The camera is in Auto Flash mode.
a No indicator on the LCD panel.
32
Additional Information
Check points and solution
polarities.
Install it with the correct polarities.
Press the Power button. When the
camera is on, the lens protrudes.
The flash is being charged. Once take
your finger away from the Shutter
Release button, lightly press the button
again, and release the shutter after the
green LED stops blinking and stays lit.
The battery is exhausted. Replace it with
a new one.
extremely short.
Move away from the subject approx. 0.7m
(2.3 ft.), or to take the picture in Macro
mode.
The flash is being charged. Once take
your finger away from the Shutter
Release button, lightly press the button
again, and release the shutter after the
green LED stops blinking and stays lit.
In this mode, the flash will not fire when
the subject is bright enough. To fire the
flash, select Anytime Flash mode.
The battery is exhausted. Replace it with
a new one.
Ref. page
7
8
6,20,
22,23
7
6,27
6,20,
22,23
22
7
Publicité
