Installation - Technics SH-1000R Manuel D'utilisation

Installation

Install the unit on a horizontal surface protected from vibrations.
Keep this unit as far as possible from speakers.
*See "Notes for installation" as well in the SP-10R operating instructions.
 If the unit rattles when installed, adjust by inserting insulators. (  below)
 Do not draw the unit forcibly after installation. Doing so may damage the insulator or floor surface.
 Always use two people or more to perform the task.
Adjusting the height to make the unit horizontal
1
Raise the main unit to turn the
insulators and adjust the height.
 Clockwise (to the right hand) when seen
from below: Lowered
 Counter-clockwise (to the left hand)
when seen from below: Raised
Attention
 Do not turn the insulators too far.
Doing so may cause them to come off or damage them.
It is recommended that the unit be used without the insulator attachments normally.
Use the insulator attachments according to the installation environments or your preference.
 Vibration absorption is disabled and the structure becomes rigid when the insulator attachments
are attached.
 Howling may occur in some installation environments.
 Howling may occur as a result of attaching insulator attachments.
1
Remove the insulators.
 Perform the task by placing the packing
cushion or the like under the unit.
2
Attach the insulator attachment
by screwing it on the insulator.
 This makes the insulator lose its
cushioning function.
Insulator
attachment
Cushion
3
Attach the insulators.
Attention
 Be careful not to lose balance.
08
(18)
English
Installation
Insulator attachment
Increases
the height
Packing cushion
Detach
Reduces
the height
Attach