Connections And Installation; Connecting To A Pre-Main Amplifier Or Component System / Connecting To A Mixer - Technics SL-1210MK7R Mode D'emploi

Connections and installation

 Turn off all units and disconnect the AC mains lead from the socket before making any
connections.
 Connect the AC mains lead only after all other connections are completed.
 Be sure to connect the PHONO earth lead. Otherwise mains hum may occur.
 Refer also to the instruction manual of the connected device.
Connect the PHONO cable and
1
PHONO earth lead to the PHONO
input terminals of the connected
equipment.
 You will not have adequate volume or
sound quality if the connected amplifier
has no PHONO input terminals.
Connecting to a pre-main amplifier or component system /
Back of main unit
L
PHONO
EARTH
R
PHONO OUT
R L
PHONO cable/
PHONO earth lead
L
R
PHONO
EARTH PHONO
Amplifier (not included)
Attention
 Tighten the PHONO earth terminal using a Phillips head screwdriver.
Note
 The operation switch does not separate entire unit from mains even if in "OFF" position.
Remove the plug from the mains socket if you will not be using the unit for an extended period of
time. Place the unit so that the plug can be easily removed.
12
(12)
English
Connecting to a mixer
AC mains lead
To a household
mains socket
Connect the AC mains lead.
2
 Confirm the wattage of the AC outlet on
the connected equipment before using it
for this unit.
For the power consumption of this unit,
see the specifications. ( 23)
Back of main unit B
L
PHONO
EARTH
R
PHONO OUT
PHONO
PHONO
earth lead
cable
R L
B
IN
R L
PHONO
R L
Audio mixer
 Refer to the operating instructions of
the audio mixer sold separately.
Back of main unit A
L
PHONO
EARTH
R
PHONO OUT
PHONO
cable
R L
A
IN OUT
L
R R L
PHONO
PHONO
R L
PHONO