Putting The Player Together - Technics SH-1000R Manuel D'utilisation

Putting the player together

 For how to assemble or remove the turntable, see the SP-10R operating instructions.
 Use the tonearm base (SH-TB10) sold separately when mounting a tone arm. For details on how to
mount, see the operating instructions of the tone arm to be mounted.
Select a short-type tonearm base from the model numbers listed below when mounting it on the
standard position for mounting the tonearm base.
To mount SH-TB10-S on the standard position for mounting the tonearm base, see the section of
installation (  100).
Tonearm base
SH-TB10RT1-S
SH-TB10TC1-S
SH-TB10JL1-S
SH-TB10SM1-S
Mount the tone arm on the SP-10R main unit
1
Mount your tone arm to
the tonearm base.
 Refer to your tone arm leaflet.
2
Mount the tonearm base on the
SP-10R main unit.
 Mount in the appropriate location.
 Fit the projections and screw holes of the
tonearm base in the SP-10R main unit
and tighten it (at three locations) with the
mounting screws and washers supplied with
the tonearm base using the hex wrench.
Insert the pin on the tonearm base into
the pin hole to position.
Before putting the player together
Tone arm (Short-type)
Manufacturer
ortofon AS-212S, RS-212D
Technics EPA-100mk2
JELCO SA-250
SME M2-9R
Model number
Standard position
for mounting the
tonearm base
Washer
Screw
English
05
(15)