Technics SH-1000R Manuel D'utilisation page 17

5
Put the main unit vertically on a side
on the protective sheet that came
with the main unit.
 Make sure there are no protruding objects,
such as screws, under the protective sheet.
 Be careful the main unit does not lose
balance and tip over.
6
Tighten the screw set for SP-10R
using the accessory hex wrench.
(The seven locations indicated in the
figure right)
 Check that all nine screws including the
two tightened in step 4 have been firmly
tightened.
7
Attach the insulators to the unit.
 Place two packing cushions under the main
unit to lift it, and turn the insulators clockwise
(to the right hand) when seen from below.
8
Mount the turntable on the SP-10R
main unit.
 See "Fitting the turntable" in the SP-10R
operating instructions.
Protective sheets
Packing cushion
English
07
(17)