Technics SH-1000R Manuel D'utilisation page 16

Putting the player together
1
Tighten the detachable handle
screws supplied with SP-10R into the
detachable handle mounting holes
(at two locations) on the SP-10R
main unit.
Attention
 Tighten the detachable handle by turning it 5 or
more times. If you have tightened it until the end,
loose a little bit. Do not tighten it firmly.
2
Slowly lift the SP-10R main unit and
place it on the turntable base.
 Be careful not to catch the control unit
connection cable.
3
Remove the insulators.
 Place two packing cushions under the main
unit to lift it, and turn the insulators counter-
clockwise (to the left hand) when seen from
below.
4
Place one packing cushion under the
main unit to put it at an angle to
tighten the screw set for SP-10R using
the accessory hex wrench.
(The two locations indicated in the
figure right)
 Attach the screw, washer and belleville spring
in the order as shown below.
The attaching order
Belleville
springs
Washers
Screws
06
(16)
English
Mounting on the turntable base
Protective sheets
(continued)
Detachable handle
mounting hole
Detachable
handle
Pass the control unit connection cable
through the hole on the turntable base.
Packing cushion