Fit The Dust Cover - Technics SH-1000R Manuel D'utilisation

1
While holding the dust cover
from both sides, put it in place by
aligning its four corners with the
four corners of the unit.
 When removing, lift the dust cover
straight up.
The combination of the following tonearm base
and tone arm will cause interference with the dust
cover. Therefore, remove the dust cover.
Tonearm base
Manufacturer
SH-TB10JL1-S JELCO
Attention
 Do not use the dust cover if you have a second tone arm connected.
 Remove the dust cover while playing.


Clearance for installing the dust cover ( : Clearance)
Dust cover

Fit the dust cover

Tone arm (Short-type)
Model number
SA-250
145.7 mm
5 mm
37.4 mm
137.2 mm
09
(19)
English