Teac SR-L100 Manuel Du Propriétaire page 34

If you have problems with your system, look
through this chart and see if you can solve
the problem yourself before calling your
dealer or TEAC service center.
General
No power
e Check the connection to the AC power
supply. Check and make sure the AC
source is not a switched outlet and
that, if it is, the switch is turned on.
Make sure there is power to the AC
outlet by plugging another item such as
a lamp or fan into the outlet.
No sound from speakers.
e Select the source by pressing the
TUNER, CD or AUX button.
e Adjust the volume.
e Pull out the headphone's plug from the
PHONES jack.
e If "MUTING" is blinking, press the
MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar
appliances. Install the unit apart from
them, or turn them off.
Remote control doesn't work.
e Press the STANDBY/ON switch to turn
the unit on.
e If the battery is exhausted, replace it
with a new one.
e Use remote control unit within the
range (5 m) and point at the remote
sensor on the front panel.
e Clear obstacles between the remote
control unit and the main unit.
e If a strong light is near the unit, turn it
off.
34
Troubleshooting
CD Player
Will not play.
e Load a disc with the playback side
facing away.
e If the disc is dirty, clean the surface of
the disc.
e A blank disc has been loaded. Load a
prerecorded disc.
e Depending on the disc, etc. it may not
be possible to play back CD-R/RW discs.
Try again with another disc.
e You cannot play back unfinalized CD-
R/RW discs. Finalize such a disc in a CD
recorder and try again.
Sound skips.
e Place the unit on a stable place to avoid
vibration and shock.
e If the disc is dirty, clean the surface of
the disc.
e Don't use scratched, damaged or
warped discs.
Tuner
Cannot listen to any station, or signal is
too weak.
e Tune in the station properly.
e Rotate the FM antenna (or the main
unit) for the best reception position.
If normal
recovered, unplug the power cord from
the outlet and plug it again.
operation cannot be