Tylo H2 Notice De Montage Et D'utilisation page 7

The panel can be set to automatically lock the buttons. Locking
can be performed with or without a code.
To program automatic keylock:
1. Select Settings.
2. Select General.
3. Select Keylock.
4. Select Activate with code or Activate without code depend-
ing on whether a code is needed.
If selecting Activate with code the code should be changed.
Change code by selecting Set code. Enter the existing code
first (default is 0000) and then the new code. Confirm the new
code.
NOTE! If the panel is code-protected, an external
switch connected to the panel will still work. For this
function, see The section called External ON/OFF
switch (option), Page 5.
To enter how long it takes before the panel automatically locks:
1. Select Settings.
2. Select General.
3. Select Keylock.
4. Select Delay.
5. Enter the time until panel lock (10 sec. - 5 min., default is 15
sec.).
Drying mode
Once operating time expires or the heater is switched off via OFF,
the sauna will start drying (if the water reservoir has been in use,
humidity setting 1-10). Drying is active for 20 minutes, after which
the heater will switch off. The drying mode can also be cancelled
manually by pressing OFF. The drying mode will be shown in the
status bar by ON/OFF STATUS changing to DRYING STATUS
(see Figure 13, Page 5).
Figure 13: DRYING STATUS
External ON/OFF switch (option)
General
External ON/OFF switches are available with impulse or constant
activation. The control panel detects automatically which activa-
tion is used. However, the switch function can vary depending on
activation. Switches with constant activation can only use the On/
Off function. Impulse switches can be given various functions, de-
pending on whether they can be programmed with On/Off or Ex-
tended bathtime.
On/Off
On/Off (impulse and constant activation, not suitable for calendar
programming)
Switches with constant activation:
• To run the system for a preprogrammed time in External
switch bathtime: press the switch once.
All manuals and user guides at all-guides.com
•
Impulse switches:
•
•
Extend bathtime
Extend bathtime (with impulse only):
•
•
•
Setting a function
To set a function for impulse switches:
1. Select Settings.
2. Select Service.
3. Select Settings.
4. Select External switch function.
5. Select between On/Off and Extended bathtime.
Setting External switch bathtime
To define the sauna time for pressing the external switch:
1. Select Settings.
2. Select Service.
3. Select Settings.
4. Select External switch bathtime:
5. Enter the time and confirm with OK.
Extra control panel (option)
All connected control panels work in parallel, i.e. making a se-
lection on one panel will activate the same selection on the oth-
er connected units. However, there are certain individual settings
which do not affect running of the heater, but which are selected
on each panel:
•
•
•
•
To switch off the system, press the switch once more.
To run the system for a preprogrammed time in External
switch bathtime: press the switch once. (Functions if the sys-
tem is in Standby or Off.)
To switch off the system, press the switch once more. (If the
heater is in a program, it will be shut down and wait for a new
program or new On-activation.)
To run the system for a preprogrammed time in External
switch bathtime: press the switch once.
To restart the time, press once more.
When the time has expired, the heater will return to the setting
it would have been in if the switch had not be activated.
Automatic keylock on/off
Code lock on/off
Delay time
Vibration on/off
5