Teaching The Camera To The Recorder; Operating And Configuring Via App - Abus TVAC18000A Notice D'utilisation

6.5 Teaching the camera to the recorder

To connect a camera with the recorder, proceed as follows:
1. Connect the camera and the recorder to the power supply.
2. In the recorder menu, select "Camera", then "Pairing" and the required camera (1-4). The system
counts down from 60 seconds.
3. Press the PAIRING button briefly (approx. 2–3 seconds) on the camera cable during these 60 seconds.
4. The LINK LED is lit up continuously once the connection is established.
Note:
Please note that the connection can take up to 60 seconds.

7. Operating and configuring via app

The wireless recorder gives you the option of switching to live on the cameras and to configure the
recorder. The app for this device can be found in the App Store under the name of "TVAC18000".
If you want to access the live picture when you are out and about, proceed as follows:

Network connection

"TVAC18000" app
Make sure that the recorder is connected to the internet and that an
internet connection is available.
The recorder is already configured on DHCP as standard. If your
router is also configured with DHCP you will receive a network
address automatically. You can now start accessing the app without
any additional configuration.
Download the "TVAC18000" app and install it on your smartphone.
42
English