Tennant 2100 Manuel De L'opérateur page 15

TRANSPORTING MACHINE
1. Unplug the power cord and remove the pad from
the machine. Neatly coil the cord around the cord
hook and handle to prevent cord damage.
2. Load the machine using a recommended loading
ramp or carefully lift the machine with adequate
assistance.
FOR SAFETY: When transporting machine, get
assistance when lifting machine.
3. Secure machine with tie–down straps when
transporting by vehicle.
WARNING: Do Not Use Outdoors. Do Not
Expose to Rain. Store Indoors.
TROUBLE SHOOTING
PROBLEM
Machine does not
operate.
Machine operates
with a wobble or jerky
motion. motion.
Tennant 2100/2120/2130/2140/2150 (10–02)
All manuals and user guides at all-guides.com
CAUSE
Faulty power cord.
Tripped building circuit breaker.
Faulty machine wiring.
Faulty On/Off lever switch.
Faulty motor.
The cord connection between the handle and
base is not correctly inserted.
Soiled Pad.
Improper pad/brush for application
Pad driver/brush not installed correctly.
Pad/brush unevenly worn.
Pad not properly centered.
RECOMMENDED STOCK ITEMS
Refer to the Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description as shown (Figure 14).
FIG. 14
SOLUTION
Contact Service Center.
Reset circuit breaker in building.
Contact Service Center.
Contact Service Center.
Contact Service Center.
Ensure correct cord connection.
Replace Pad.
Change to proper pad/brush.
Remove and reinstall pad driver/brush.
Replace pad/brush.
Remove and reinstall pad.
OPERATION
15