RIB TOUCH Mode D'emploi page 9

Sliding gate systems
1 - Unscrew fastening screws from upper cover
and remove the cover from TOUCH (Pic. 2
- particular 1).
2 - Unscrew fastening screws from lower cover
and remove the cover from TOUCH (Pic. 2
- particular 2).
3 - Mark the upper side (S) of the fastening slot
on the side of the aluminium profile (Pic. 2
- particular 3).
4 - Position the safety strip in its proposed working
position. In case of vertical mounting, keep a
minimum distance of 30 mm from the ground
(Pic. 2 - particular 2).
5 - Drill a hole in the wall at about 7 mm below
the reference point and fix the spring with
opportune screws for metal or wall anchor
screws (Pic. 2 - particular 4).
6 - Position TOUCH on the spring and secure it in
place by pulling downward.
7 - Mark the holes to be drilled in the wall in
correspondence with -C- and -D- (Pic. 2
- particulars 1 and 2).
8 - Remove the profile and drill the holes as
indicated into the step above.
* Once the safety edge is fixed, make sure
there are no gaps in between the parts
indicated.The rubber profile and the parts
above it, must perfectly adhere to avoid the
passage of rain or insects.
Possible positioning
9
Sliding door systems
*
G
B
1
2