Wolf Garten Campus 400 B Mode D'emploi page 13

Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Oil Fill H
Check oil level with mower standing on level ground.
Fill crankcase with quality oil SAE 30 up to the mark „Full" on
dipstick. (Do not overfill.) Capacity approx. 0,6 litre. Screw in
dipstick according to illus.
Filling with Petrol J
Do not smoke - no naked flames!
off engine.
Avoid spilling petrol when engine is warm.
Use „low-octane petrol" (do not use Super Plus).
Avoid petrol spillage.
Do not inhale vapour.
Hanging the grass bag
Only when mower is stationary and rotating blade
has come to complete standstill.
1. Lift the protective fl ap.
2. Hang the grass bag in the chassis with the hooks in the
recesses (see arrow).
3. Replace the protective fl ap.
Use of height adjustment
Only when mower is stationary and rotating blade
has come to complete standstill.
• Place hand into handle bar and depress button (1). Lift or
lower chassis until it engages into required position (2).
• The wheels must all be at the same cutting height
setting!
• If possible, mow when grass is dry in order to protect turf.
Do not set cutting position too low when mowing very tall
or wet grass.
Maintenance
Disconnect spark plug cap and starter key before
proceeding
Clean mower thoroughly after each mowing with cloth or
brush.
Do not spray with water. Keep mower in a dry room.
Cleaning operations and blade change
1. Pull off the sparkplug connector!
2. Raise the cutting height to its highest position
3. For cleaning work and blade replacement tilt the mower back
as shown in the illustration.
14
All manuals and user guides at all-guides.com
K
L M
Q
Start
G N O
• On a fl at surface, if possible not in high grass.
1. Firmly press the primer on the motor (three times)
2. Raise and hold the safety bracket
3. Pull starter grip O and return it slowly by hand.
4. Push the choke back as soon as the engine has warmed
Wheel drive (Campus 460 BA)
1. Wheel drive on: Raise drive bracket
2. Wheel drive off: Relapse drive bracket
Stop Motor
G
Release safety bracket
Tips for mowing P
• To prevent strips of grass from being left unmowed, the
cutting paths must always overlap a few centimeters.
• Always turn the mower on a surface that has already been
mowed.
Emptying the grass bag
Only when mower is stationary and rotating blade
has come to complete standstill.
The grassbox is full and should be emptied as soon as grass
clippings remain uncollected on the ground behind your mower.
Change of Cutter blades
Disconnect spark plug cap and starter key before
proceeding
Blade should always be sharpened by an approved Service
Centre. Change blade according to drawing.
Information for Service Centre, blade retaining screw to be
tightened to: screw = 51-68 Nm.
N
(1).
G
G
(2).
(2)
G
(1).
R
(1).