Belkin Bitronics AutoSwitch F1U128-KIT Guide De L'utilisateur page 31

Windows ® 95 / 98 and NT ®
(continued)
Usage in Windows NT
®
In Windows NT , you can perform the same installation as in the Windows 95/
® ®
98 procedure above. Make sure the power supply is connected to the
Bitronics switch, otherwise, there may be a significant delay in the processing
of requests from NT ® -based machines.
The Printer properties in Windows NT ® is slightly different. After installing the
software and restarting the computer, go to the printer properties and select
the Ports tab. To find the correct ports to be used with the Bitronics switch,
you must scroll down the list until the LPx1: PA (autoswitch) comes up. Put a
checkmark on the port that connects to the printer. In this case, it is Port A on
the Bitronics switch:
26