Publicité
Les langues disponibles
Les langues disponibles
If " Smart Space" appears in the display
(Smart Space)
There has been an extended silence of 4 to 30 seconds
in length during recording. The silence is replaced
with a blank of about 3 seconds and the deck continues
recording. Note that new track numbers may not be
marked for portions recorded while this function is
activated. Also, the Smart Space Function does not
activate even if there has been an extended silence of 4
to 30 seconds in length when the deck started
recording from the blank portion.
To turn off the Smart Space Function and Auto Cut
Function
1 While the deck is stopped, press MENU/NO twice
to display "Setup Menu".
2 Turn AMS to select "Setup 05", then press AMS.
3 Turn AMS to select "S.Space Off", then press AMS.
4 Press MENU/NO.
To turn on the Smart Space Function and Auto Cut
Function again
1 Do Steps 1 and 2 in "To turn off the Smart Space
Function and Auto Cut Function" above.
2 Turn AMS to select "S.Space On", then press AMS.
3 Press MENU/NO.
Notes
• When you turn off the Smart Space Function, the Auto Cut
Function is also turned off automatically.
• The Smart Space Function and Auto Cut Function are
factory set to on.
• If you turn off the deck or disconnect the AC power cord,
the deck will recall the last setting (On or Off) of the Smart
Space and Auto Cut Functions the next time you turn on
the deck.
Sw itching the bit length
You can improve the recording quality by switching
the bit length to match the CD player, DAT deck or
other digital components connected to the digital input
connector.
1
While the deck is stopped, press MENU/NO
twice to display "Setup Menu".
2
Turn AMS to select "Setup 12", then press AMS.
3
Turn AMS to select the desired bit length, then
press AMS.
4
Press MENU/NO.
Downloaded from:
https://www.usersmanualguide.com/
Recording on M Ds
Notes
• This function operates only for the digital signal input
through the digital input connector.
• The bit length is normally set to 20 bits, but you can select
from 24, 20 or 16 bits.
• If you switch the bit length during recording, the sound
drops out momentarily.
Playing back tracks just recorded
Do this procedure to immediately play back tracks that
have just been recorded.
Press ( immediately after stopping recording.
Playback starts from the first track of the material just
recorded.
To play from the first track of the M D after
recording
1 Press p again after stopping recording.
2 Press (.
Playback starts from the first track of the MD.
Recording Over Existing Tracks
Follow the procedure below to record over existing
material just as you would on an analog cassette tape.
1
Do Steps 1 to 8 in "Recording on an MD" on
pages 9 and 10.
2
Turn AMS (or press = or +) until the
number of the track to be recorded over appears.
3
To record from the start of the track, continue
from Step 9 in "Recording on an MD" on page 10.
z
While " Tr" flashes in the display
The deck is recording over an existing track, and stops
flashing when it reaches the end of the recorded
portion.
z
To record from the middle of the track
1 After Step 2 above, press ( to start playback.
2 Press P where you want to start recording.
3 Continue from Step 9 in "Recording on an MD" on
page 10.
Note
You cannot record from the middle of an existing track when
the "PROGRAM" or "SHUFFLE" is on.
15
GB
Publicité
