Télécharger Imprimer la page

Sony MDS-JA555ES Mode D'emploi page 13

Publicité

Les langues disponibles

Les langues disponibles

Recording on M Ds
Not es on Recording
If " Protected" alternates w ith " C11" in the display
The MD is record-protected. Close the slot to record
on the disc (see "To protect an MD against accidental
erasure" on page 11).
If " Din Unlock" alternates w ith " C71" in the display
• The digital program source is not connected as you
set with the INPUT in Step 4 on page 9.
To continue, connect the program source properly.
• The program source is not on.
Turn on the program source.
Depending on the menu settings and source being
recorded, track numbers are marked in follow ing
w ays:
• When recording from a CD or MD with the INPUT
set at COAX, OPT1 or OPT2 and the source
connected through the respective digital connector:
The deck automatically marks track numbers in the
same sequence as the original. If, however, a track is
repeated two or more times (e.g. by single-track
repeat play) or two or more tracks with the same
track number (e.g. from different MDs or CDs) are
played, the track or tracks are recorded as part of a
single, continuous track with a single track number.
If the source is a CD, track numbers may not be
marked for tracks of less than 4 seconds.
• When recording from some CD players and multi
disc players connected through one of the digital
input connectors with the INPUT set at the
respective digital position:
The deck may not automatically mark track
numbers. In these cases, mark the track numbers
after recording, using the deck's Divide Function (see
"Dividing Recorded Tracks" on page 38).
• When recording from a source connected through
the LINE(ANALOG) IN jacks with the INPUT set at
ANALOG or when recording from a DAT or satellite
broadcast connected through one of the digital input
connectors with the INPUT set at the respective
digital position and "T.Mark Off" selected in Setup
Menu 02:
The source will be recorded as a single track.
• Even while recording an analog source or a DAT or
satellite broadcast, you can mark track numbers if
"T.Mark LSyn" is selected in Setup Menu 02 (see
"Marking Track Numbers While Recording" on
page 17).
Downloaded from:
https://www.usersmanualguide.com/
Recording on M Ds
• When recording from DAT or satellite broadcasts
with the INPUT set at the respective digital position,
the deck automatically marks a track number
whenever the sampling frequency of the input signal
changes regardless of the Setup Menu 02 setting.
z
You can mark track numbers during or after
recording
For details, see "Marking Track Numbers While
Recording" (page 17) and "Dividing Recorded Tracks"
(page 38).
When " TOC Writing" flashes in the display
The deck is currently updating the Table Of Contents
(TOC). Do not move the deck or pull out the AC
power cord. Changes to an MD made through
recording are saved only when you update the TOC by
ejecting the MD or changing the deck to standby by
pressing the 1 /u switch.
The M D deck uses the SCM S (Serial Copy
M anagement System on page 49)
MDs recorded through digital input connector cannot
be copied onto other MDs or DAT tapes through the
digital output connector.
When the deck is recording or in recording pause,
digital signals input through one of the digital input
connectors are output to the respective digital
output connector w ith the same sampling rate
To change the digital input signal to another sampling
rate for output (without recording it to an MD), use
Input Monitor Function (see page 14).
13
GB

Publicité

loading