Quickly Attenuating The Sound; Selecting The Spectrum Analyzer - Sony CDX-M770 Mode D'emploi

By pushing in and rotating the control
Push in and rotate the control to:
– Receive preset stations.
– Change the disc*.
* When an optional CD/MD unit is connected.
Tip
You need to push in and rotate the control each time
you select a preset station and a disc.
Changing the operative direction
The operative direction of controls is factory-set
as shown below.
To increase
To decrease
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
RM-X5S
Rev Nor
Set the Rev/Nor-select switch to "Rev."
RM-X4S
Press (SOUND) for 2 seconds while
pushing the VOL control.
PRESET/DISC
control
Quickly attenuating the
sound
(With the rotary commander or the card
remote commander)
Press (ATT) on the rotary commander
or card remote commander.
"ATT on" appears in the display momentarily.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
Selecting the spectrum
analyzer
The sound signal level is displayed on a spectrum
analyzer. You can select a display for 5 patterns
(A-1, A-2, B-1 to B-3), or the automatic display
mode and "OFF" where all the patterns appear.
1
Press (SOURCE) to select a source
(radio, CD, or MD).
2
Press (MENU).
3
Press M or m repeatedly until "SA"
appears.
4
Press < or , repeatedly to select the
desired setting.
5
Press (ENTER).
33