Adjusting The Sound Characteristics; Quickly Attenuating The Sound; Changing The Sound And Display Settings - Sony CDX-F5500 Mode D'emploi

Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press the select button repeatedly
until "BAL," "FAD," "LPF" or "SUB"
appears.
Each time you press the select button, the
item changes as follows:
LOW* 1 t MID*
BAL (left-right) t FAD (front-rear) t
LPF (low pass filter)*
SUB (subwoofer volume)*
*1 When EQ3 is activated (page 21).
*2 When "SUB" is selected (page 20).
*3 The cut off frequency is adjustable to 78 Hz,
125 Hz or OFF.
*4 The volume level is adjustable between –10
and +10 steps. (Below –10, "ATT" is displayed.)
2
Rotate the volume control dial to
adjust the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
(With the rotary commander or the card
remote commander)
Press (ATT).
After "ATT-ON" momentarily appears,
"ATT" appears in the display.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
20
1 t HI* 1 t
2 3 t
*
2 4
*
Changing the sound and
display settings
The following items can be set:
• REAR/SUB* 1 — to switch the audio output
REAR or SUB.
– Select "REAR" to output to a power amplifier.
– Select "SUB" to output to a subwoofer.
• A.SCRL (Auto Scroll)*
• M.DSPL (Motion Display) — to turn the
motion display on or off.
– Select "ON" to activate the motion display
(the moving pattern appears in the display).
– Select "OFF" to deactivate the motion display.
• DEMO* 1 — to turn the demonstration display
on or off.
– Select "ON" to activate the demonstration
display (The demonstration starts about 10
seconds after the unit is turned off).
– Select "OFF" to deactivate the
demonstration display.
• BEEP* 3 — to turn the beeps on or off.
• DIM — to change the brightness of the display.
– Select "ON" to dim the display.
– Select "OFF" to deactivate the Dimmer.
2
(page 12).