Erreka AXIL Serie Instructions D'installation page 28

ELECTRICAL CONNECTIONS
Models 230V and 120V
Earth-fault protection
Opening
Common
Closing
m
ATTENTION:
• Always connect the ground cable as stipulated by
enforced norms (EN 60335-1, EN 60204-1).
• For the connection only use cables 4G0,75 or 4G1 with
ø external 10 mm maximum
Finish the electrical connections closing the rear space of the
motor with the plastic cover and locking the cable press.
Models 24V
Earth-fault protection
+
-
not used
m
ATTENTION:
• Always connect the ground cable as stipulated by
enforced norms (EN 60335-1, EN 60204-1).
• For the connection only use shielded cable AYCY4.
Finish the electrical connections closing the rear space of the
motor with the plastic cover and locking the cable press.
ENCODER connection
m
ATTENTION:For encoder operation, when in the closed
position, both gate panels must rest against a mechanical stop.
Hereafter the directions to follow to connect the cables of the
encoder to the control unit:
ENCODER CONTROL UNIT
M
RED V+ (brown)
O
T
BLACK GND (shield)
O
R
BLUE SNG1 (green)
1
M
RED V+ (brown)
O
T
BLACK GND (shield)
O
R
BLUE SNG1 (green)
2
All manuals and user guides at all-guides.com
m
with a 4x0,22 shielded cable with polyethylene sheath
m
the accessories is connected to the common accessories.
Finish the electrical connections closing the rear space of the
motor with the plastic cover and locking the cable press.
24
ATTENTION: extensions of the cables must be made only
ATTENTION: check that the ground of the power supply of