Safety Notes - Monacor DMT-2010 Mode D'emploi

7 Jack for the red test lead for measuring currents exceeding 400 mA to
GB
10 A max.
8 Jack for the red test lead for measuring voltages, currents up to
400 mA, resistances, diodes, capacitors, frequencies and for measur-
ing the duty cycle; when measuring temperatures, connect the positive
pole of a type K temperature sensor to this jack
9 Jack for the black test lead or, when measuring temperatures, for the
negative pole of a type K temperature sensor

2 Safety Notes

The meter corresponds to all required directives of the EU and is there-
fore marked with
1. Wear protective gloves to protect yourself against electric shock.
2. When applying the test tips, make sure that your fingers will be pro-
tected behind the collars of the tips.
3. Never perform any measurements when the meter or the test leads
are damaged. Always replace damaged test leads by original test
leads.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it against dripping water
and splash water, high air humidity and heat (admissible ambient tem-
perature range 0 – 50 °C).
G
For cleaning only use a dry, soft cloth; never use water or chemicals.
G
No guarantee claims for the unit and no liability for any resulting per-
sonal damage or material damage will be accepted if the relevant
safety regulations for handling voltages equal to or higher than 42 V
are not observed, if the meter is used for other purposes than originally
intended, if it is not correctly connected or operated, if it is overloaded
or not repaired in an expert way.
If the meter is to be put out of operation definitively, take it to a
local recycling plant for a disposal which is not harmful to the
environment.
16
.
WARNING: With this meter, dangerous voltages can be
measured. Particular attention should be paid when measur-
ing voltages equal to or higher than 42 V!