Safety Notes; Applications - Monacor MT-200 Mode D'emploi

7 Fixing screw of the mechanical zero point of the instrument:
with the multimeter switched off adjust the scale pointer to zero
by the screw
8 Adjusting knob "OHMS ADJUST" for the 0 Ω calibration: set the
range switch (1) to the desired ohm range, short-circuit the test
lead tips, and adjust the scale pointer to 0 Ω with the wheel
9 Jack "DC 10A" for the red test lead (positive pole) for measuring
in the 10 A DC current range
10 Jack " V.Ω.A" for the red test lead (positive pole) for measur-
ing in all ranges, except in the 10 A DC current range

2 Safety Notes

This appliance corresponds to the directive for electromagnetic com-
patibility 89/336/EEC and the low voltage directive 73/23/EEC.
With this instrument dangerously high voltages can be measured.
When measuring voltages from 42 V on be especially careful.
Always take care that the test leads are in perfect condition.
Damaged test leads must be replaced.
Always watch the following items regarding the operation:
The unit is only suitable for indoor use.
Protect the unit from humidity and heat (permissible ambient
temperature range 0–40 °C).
If the unit is used for purposes other than originally intended, if it
is overloaded or operated, connected or repaired in the wrong
way, there is no liability for possible damage.
Only use a dry, soft cloth for cleaning, by no means chemicals or
water.
If the unit is to be put out of operation definitively, bring it to a
local recycling plant for disposal.

3 Applications

With this multimeter DC and AC voltages, DC currents, resistances
as well as decibel can be measured. Furthermore 1.5 V (AA size)
and 9 V batteries can be tested. For the continuity check a buzzer
is provided. With model MT-300 transistors can additionally be
tested (display PNP or NPN type by LEDs).
GB
13