Télécharger Imprimer la page

Angelcare AC701 Manuel De L'utilisateur page 90

Masquer les pouces Voir aussi pour AC701:

Publicité

Les langues disponibles

Les langues disponibles

16.9 DO NOT attempt to recharge batteries
provided with or identified for use with
this product that are not intended to be
charged. The batteries may leak corrosive
electrolyte or explode.
16.10 DO NOT attempt to rejuvenate the
batteries provided with or identified for
use with this product by heating them.
Sudden release of battery electrolyte may
occur, causing burns or irritation to eyes
or skin.
16.11 If and when necessary, the batteries
must be replaced with identical new ones
or equivalent (volts and size). If a battery
to be replaced is connected with other
batteries in series, replace the other
batteries at the same time as well. DO
NOT mix old and new batteries.
16.12 Reverse polarity installation of the
batteries in the end product must be
avoided. Reverse insertion of batteries
can cause charging, and that may result
in leakage or explosion.
16.13 Remove batteries from this product
if you store the product over 30 days
because the batteries could leak and
damage the product.
16.14 Discard 'dead' batteries as soon as
possible since 'dead' batteries are more
likely to leak in a product. If a battery has
leaked or vented, it should be replaced
immediately using protective gloves.
16.15 DO NOT store this product, or the
batteries provided with or identified for
use with this product, in high-temperature
areas.
FCC AND IC REGULATIONS
RF radiation exposure statement
The Nursery Unit complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. Caution: To maintain the compliance with the FCC's RF
exposure guideline, install the Nursery Unit at least 20cm from nearby baby and persons.
For body worn operation, this Parent Unit has been tested and meets the FCC RF exposure
guidelines. Use the supplied belt clip only. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines.
Industry Canada
This product meets the applicable Industry Canada technical specifications.
CAN ICES-3 (B)/NMB-3 (B)
90
All manuals and user guides at all-guides.com
(North America Only)
17. Modifications not authorized by the
manufacturer may void users authority to
operate this device.
17.1 NOTE : This equipment has been
tested and found to comply with Part 15
of the FCC Rules and the Industry Canada
licence-exempt RSS standard(s). These
limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications.
17.2 However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment OFF and ON ,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between
• Connect the equipment into an
• Consult the dealer or an experienced
17.3 This device complies with part 15 of
the FCC Rules and the Industry Canada
licence-exempt RSS standard(s). Operation
is subject to the following two conditions:
1) This device may not cause harmful
2) This device must accept any
WARNING
the equipment and receiver.
outlet on a circuit different from that
to which the receiver is connected.
radio/TV technician for help.
interference, and
interference received, including
interference that may cause undesired
operation.

Publicité

loading