Beko RDNE390M21SX Manuel D'utilisation page 23

• The freezer or cooler door may be ajar.
>>> Check that the doors are fully
closed.
• The product may be set to temperature
too low. >>> Set the temperature to a
higher degree and wait for the product to
reach the adjusted temperature.
• The cooler or freezer door washer
may be dirty, worn out, broken or not
properly settled. >>> Clean or replace
the washer. Damaged / torn door
washer will cause the product to run for
longer periods to preserve the current
temperature.
The freezer temperature is very
low, but the cooler temperature is
adequate.
• The freezer compartment temperature
is set to a very low degree. >>> Set the
freezer compartment temperature to a
higher degree and check again.
The cooler temperature is very
low, but the freezer temperature is
adequate.
• The cooler compartment temperature is
set to a very low degree. >>> Set the
freezer compartment temperature to a
higher degree and check again.
The food items kept in cooler
compartment drawers are frozen.
• The cooler compartment temperature is
set to a very low degree. >>> Set the
freezer compartment temperature to a
higher degree and check again.
The temperature in the cooler or
the freezer is too high.
• The cooler compartment temperature
is set to a very high degree. >>>
Temperature setting of the cooler
compartment has an effect on the
temperature in the freezer compartment.
Wait until the temperature of relevant
parts reach the sufficient level by
changing the temperature of cooler or
freezer compartments.
• The doors were opened frequently or
kept open for long periods. >>> Do not
open the doors too frequently.
• The door may be ajar. >>> Fully close
the door.
• The product may have been recently
plugged in or a new food item is
placed inside. >>> This is normal. The
product will take longer to reach the set
temperature when recently plugged in or
a new food item is placed inside.
• Large quantities of hot food may have
been recently placed into the product.
>>> Do not place hot food into the
product.
Shaking or noise.
• The ground is not level or durable. >>>
If the product is shaking when moved
slowly, adjust the stands to balance the
product. Also make sure the ground is
sufficiently durable to bear the product.
• Any items placed on the product may
cause noise. >>> Remove any items
placed on the product.
The product is making noise of
liquid flowing, spraying etc.
• The product's operating principles
involve liquid and gas flows. >>> This is
normal and not a malfunction.
There is sound of wind blowing
coming from the product.
• The product uses a fan for the cooling
process. This is normal and not a
malfunction.
There is condensation on the
product's internal walls.
• Hot or humid weather will increase icing
and condensation. This is normal and
not a malfunction.
22
EN