Electrical Connection; Important; Disposing Of The Packaging; Disposing Of Your Old Refrigerator - Beko RDNE390M21SX Manuel D'utilisation

Electrical connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.

Important:

The connection must be in compliance
with national regulations.
The power plug must be easily
accessible after installation.
Electrical safety of your refrigerator
shall be guaranteed only if the earth
system in your house complies with
standards.
The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before
it is repaired! There is the risk of
electric shock!

Disposing of the packaging

The packing materials may be
dangerous for children. Keep the
packing materials out of the reach
of children or dispose of them by
classifying them in accordance with
the waste instructions stated by your
local authorities. Do not throw away
with regular house waste, throw
away on packaging pick up spots
designated by the local authorities.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator without
giving any harm to the environment.
You may consult your authorized
dealer or waste collection center of
your municipality about the disposal
of your refrigerator.
Before disposing of your refrigerator,
cut out the electric plug and, if there
are any locks on the door, make them
inoperable in order to protect children
against any danger.

Placing and Installation

A
If the entrance door of the room
where the refrigerator will be installed is
not wide enough for the refrigerator to
pass through, then call the authorized
service to have them remove the
doors of your refrigerator and pass it
sideways through the door.
Install your refrigerator to a
1.
place that allows ease of use.
Keep your refrigerator away
2.
from heat sources, humid places and
direct sunlight.
Your product requires adequate
3.
air circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and
the ceiling, rear wall and the side walls.
If the product will be placed in
4.
an alcove, remember to leave at least
5 cm clearance between the product
and the ceiling, rear wall and the side
walls. Check if the rear wall clearance
protection component is present at its
location (if provided with the product).
If the component is not available, or if
it is lost or fallen, position the product
so that at least 5 cm clearance shall
be left between the rear surface of the
product and the wall of the room. The
clearance at the rear is important for
efficient operation of the product.
Place your refrigerator on an
5.
even floor surface to prevent jolts.
10
EN